#Ip address for netgear router wndr 3700 how to#
With the multitude of routers and gateway available now, and with different firmware versions, it is impossible for AT&T Support and us to keep up with how to access and verify unless someone here on the forum has the same router as you and is willing to share their knowledge.Īs a side note, if you have an iPhone 6 or greater you can look into using WiFi Calling (WiFi-C) as an option to see if you even need to use a MicroCell. To find and verify those settings you will probably have to ask the mfr if you can't find them youself. Cisco/AT&T developed the MicroCell around 8-10 years ago when routers and LANs were not as complex so the minimum requirements were easy to meet for most folks without even having to think about it. Some newer routers seem to have changed the defaults or certainly made it more difficult to find and verify them. You will see the WAN side IP address you need to use to get access to the USB hard drive content when you are travelling, either from your computer or from your Mobile Phone. Netgear WNDR3700 - RangeMax Dual Band Wireless-N Gigabit Router. De draadloze verbindingen zijn van het type 802.11n en worden eventueel voorzien van een WPA(2. The settings are fairly basic and are probably defaulted in your old router. Netgear heeft voor zijn WNDR3700-routers nieuwe firmware uitgebracht met 1.0.4.68 als versienummer. The router requirements are given in the setup instructions and in my Tech Guide (see link in my sig). If you can, that indicates it's a router issue. I would connect the MicroCell directly to the modem, bypassing the router altogether to see if you can establish connectivity to the AT&T Mobility Servers. I'm assuming that you are not going thru any switches, PowerLine adapters, etc and that your connection is a single, uninterrputed ethernet connection. Sometimes router mfrs will have certain default settings enabled that aren't compatible with the MicroCell and you have to work with them to determine that. NAT duties handled by only one device if you have a separate router and modem (gateway)
Ports that must remain open (public and private):Ĥ43/TCP - for HTTPS over TLS/SSL for provisioning and management traffic.Ĥ500/UDP - for IPSec NAT Traversal (for all signaling, data, and voice traffic).ĥ00/UDP - for IPSec Phase I prior to NAT detection, after which 4500/UDP is used. I would connect another device the same ethernet port that you are attempting to use for the MicroCell to see if the Netgear will detect that device.Īre the following router requirements setup correctly in the Netgear: You need to have the router see the MicroCell (MAC address) first. I wouldn't worry about port forwarding yet.
This sounds like a router issue if the Netgear doesn't even "see" the MicroCell.
0 kommentar(er)
